Monday, April 9, 2018

Rebuilding The Heathit AT-1 Transmitter - Final Amplifier Tube Wiring

I finished up the next set of assembly instructions  - the wiring around the final amplifier tube.


The last toroid is another large one that is too heavy to stand in the air by its leads. so I sat it on the chassis. As this has some high voltage (close to 1000 volts), I wrapped it in electrical tape to better insulate it from the chassis.


Next up is the assembly of the coils, much of which will use heavy bus wire and be on the top of the chassis.


No comments:

Post a Comment